Fence
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & paversFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Wellborn Fence Installation: The Las Vegas Owner’s Guide
We install Wellborn-compatible fence systems and replacement parts across Las Vegas, and a full fence installation typically runs $3,500 – $9,000 installed. Replacement of a single failed section, post, or gate hardware set usually prices out well below that lead range. Most Las Vegas owners don’t call us until a gate starts dragging on the strike plate, a post leans after a monsoon gust, or a panel section sags where the soil has settled. By then, the part that failed has usually been quietly wearing out for a season or two.
Wellborn fence lines are built to hold up, but the desert works on them in specific ways. Expansion and contraction between a 115-degree July afternoon and a 45-degree January night loosens fasteners and opens seams. Caliche and decomposed granite soils shift under posts after heavy winter rain. If your gate won’t latch, your post has a lean you can see against the wall, or your panels rattle in a stiff wind, you’re already in the replacement conversation.
Key Takeaways
- Full Wellborn-compatible fence installation in Las Vegas: $3,500 – $9,000.
- Hardware and single-section swaps usually fall under that range.
- Post footing depth and soil conditions matter more in Las Vegas than fence style.
- We pull permits where eligible and issue written change orders before any price moves.
- We’re an independent contractor, not affiliated with Wellborn.
Which Wellborn Models This Applies To
Wellborn’s fence catalog spans ornamental aluminum, vinyl, and hybrid lines, and the parts are not interchangeable across them. Before you order anything, find the model label. It’s usually stamped on the inside face of a post cap, printed on a sticker on the gate frame, or noted on the original installation paperwork. If the label is gone, measure the post width, the rail spacing, and the gate frame opening, then photograph them alongside a tape measure in the frame.
The compatibility gotcha on Wellborn fencing is post-cap and rail-bracket sizing. A 4-inch nominal vinyl post from one series won’t accept a cap or bracket from another, and the difference shows up when you try to seat the hardware and it sits a sixteenth off. We’ve seen Las Vegas homeowners order what looked like the right part online and end up returning it twice because the series wasn’t matched.
The OEM-versus-aftermarket call is yours to make, and we’ll lay out both. Wellborn OEM parts fit exactly and match the finish. Quality aftermarket equivalents cost less and, in many cases, hold up just as well in desert conditions. What matters more than brand loyalty is that the part matches the series. We carry no stock and no parts on a truck, so every part is sourced to your model.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Wellborn Fence Installation Is Failing
Here’s what we actually see when we pull up to a Las Vegas property with a Wellborn fence that’s aging out.
- Gate drags or won’t latch. Hinges wear, or the post has shifted and the gate frame is out of square. If the gate swung clean last year and now catches at the bottom, the geometry moved.
- Post lean you can see against a straight line. Soil settlement, footing movement, or a rotted base. In our caliche-heavy Las Vegas soil, footings that were undersized show up first.
- Panels rattle or bow in wind. Fasteners have loosened, or a rail has separated from the post. A stiff wind should not shake a properly seated panel.
- Rust or discoloration at the joints. Coating failure at cut ends or fastener contact points. Desert sun degrades a finish faster than most people expect.
- Cracks at the post-to-rail connection. Stress concentration from thermal movement. Once a crack forms, the joint loses holding power.
Any one of these on its own might be a hardware fix. Two or more together usually means the installation needs a closer look.
Replacement Cost & What’s Included
Full Wellborn-compatible fence installation in Las Vegas runs $3,500 – $9,000. What pushes a job toward the top of that range is linear footage, gate count, and footing depth. Concrete-set footings cost more than gravel-set, and they last longer in our soil. Demolition and haul-away of the old fence adds to the total. A single section swap or a hardware replacement sits well below the lead range.
| Item | Typical Range |
|---|---|
| Full fence installation | $3,500 – $9,000 |
| Single section or post swap | Below lead range |
| Gate hardware replacement | Below lead range |
We quote parts and labor separately, in writing, so you can see what you’re paying for. Every eligible job gets a permit pulled and an inspection signed. Every completed job carries our written 90-Day Done Right Promise: if it’s not done right, Tom comes back and makes it right on one call. No surprise invoices, no change orders after the fact – every scope and price change is in writing before work starts.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
Some of this you can check yourself. Walk the fence line and look for post lean, gate drag, and rattling panels. Test the gate latch by hand. Look at the base of each post for cracks or rot. That’s a quick Saturday walk, and it tells you whether you’re dealing with one part or a bigger issue.
Where DIY goes wrong on fencing is footing and post-setting. Digging out and resetting a post in Las Vegas soil without getting depth and concrete right means the post leans again in a season, and now you’ve spent the time twice. Gate frame alignment is the other place homeowners get stuck, because squaring a gate is more finicky than it looks. If the diagnosis is a footing or a twisted frame, that’s the point to call. Call (866) 814-4155 for a free estimate, and we’ll tell you straight whether it’s a repair or a replacement.
FAQs
How long does a Wellborn fence last in Las Vegas? Most Wellborn vinyl and aluminum lines run 15 to 25 years in Las Vegas, with the sun exposure and soil conditions here driving the lower end. Footings and fasteners usually fail before the fence panels do.
Can a failing Wellborn fence be repaired instead of replaced? Yes, often. Single sections, posts, and gate hardware are commonly repairable. If several posts have moved or the line has lost plumb, replacement makes more sense, and we’ll tell you which it is before you spend anything.
How long does a replacement take? A single section or hardware swap usually finishes in a few hours. A full fence installation typically runs two to four days depending on length and footing work. We schedule it in writing before we start.
How do you source the right Wellborn part? You send us the model label or the measurements and photos, and we match them to the series. Because we carry no stock, every part is ordered to your specific model. That’s how we avoid the sizing mismatch that comes from ordering blind.
We also work with KraftMaid, Cambria, and Silestone on the remodeling side, along with our other premium lines. Barrett & Sons Construction Las Vegas is an independent contractor and is not affiliated with Wellborn.
Get Your Free Fence Estimate
If your Wellborn fence is leaning, dragging, or rattling, don’t wait for a storm to finish the job. Call (866) 814-4155 for a free estimate. A live person answers the phone around the clock. We’ll walk the line with you, tell you what’s actually failed, and quote the fix in writing – parts, labor, and any change order before we touch a nail. Ask about our published offers, including $40 Off Any Repair Over $200, a Free Second Opinion on Any Written Estimate, No Trip Charge Inside the County, and our permanent 10% Senior & Veteran discount. Proudly serving our Las Vegas neighbors.
Written by the team at Barrett & Sons Construction Las Vegas, serving Las Vegas and nearby areas.