Home additions & ADU
Kitchen remodeling
Bathroom remodeling
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Owens Corning Home Additions & ADU: The Las Vegas Owner’s Guide
We build Owens Corning home additions and ADUs in Las Vegas, and the honest answer for most owners is $45,000 – $130,000 for a framed addition and $90,000 – $220,000 for a full ADU, permitted and inspected, with a written line-item quote before anything is ordered. This isn’t same-day work, and anyone who tells you it is hasn’t pulled a permit in Clark County. The Owens Corning connection is the building envelope: their foam sheathing, weather barrier, and blown or batt insulation are what make a Las Vegas addition stand up to 115-degree summers and monsoon-driven rain without the walls sweating themselves apart.
Owners usually end up on this page one of two ways. Either they’re planning the addition and want the envelope done with materials they can look up, or they’ve already got an Owens Corning assembly in an older room and something is failing underneath – soft drywall near a window, a foam board pulling away from the studs, cold spots along an exterior wall that didn’t used to be there. Both are envelope problems, and both start with identifying what was installed.
Key Takeaways
- Installed Owens Corning home additions in Las Vegas run $45,000 – $130,000; ADUs run $90,000 – $220,000.
- Owens Corning is the envelope brand here – foam sheathing, weather barrier, insulation – not the whole system.
- Clark County permits and inspections are required on every addition and ADU we build, no exceptions.
- We’re an independent contractor working with Owens Corning products; we’re not affiliated with Owens Corning.
- Every price change is a written change order before work continues.
Which Owens Corning Models This Applies To
Owens Corning doesn’t make the lumber, the electrical, or the plumbing in your addition – they make what wraps, seals, and insulates it. That means the “models” you’re matching against are product families, not serial-numbered machines. Here’s how to tell what you’re working with.
Look at the exposed layer on the outside of the studs under your siding. If you see a foil- or white-faced rigid board, that’s Owens Corning Foamular, most commonly the NGX or the older XPS line, sold in 1″, 1.5″, 2″, and 2.5″ thicknesses with an R-value of roughly 5 per inch. If the facing is a black-and-white printed sheet stapled over the studs, that’s likely the WeatherLock or a similar weather-resistant barrier. Rolled or blown insulation tells you the batt series – the R-13 and R-15 kraft-faced batts and the R-30 to R-60 blown attic product are the usual suspects in Las Vegas homes.
Here’s the compatibility gotcha most homeowners miss: Foamular NGX carries an R-value rated at a specific thickness, and if someone before you installed 1″ board where the plans called for 2″, you’re short roughly 5 R-value points on that wall. That gap shows up as condensation on the drywall in August. Check the printed R-value on the board face if it’s visible, and measure thickness with a tape.
On the OEM-versus-aftermarket question: for foam and batt insulation, Owens Corning’s own product is what we specify because the R-value and the labeling are what the inspector checks. For fasteners, tapes, and sealants, a quality aftermarket equivalent is fine and often what we use – the building code cares about the assembly, not the label on the tape. We install Owens Corning products but we are an independent Las Vegas contractor, not affiliated with Owens Corning. We’ll also source KraftMaid, Cambria, and Silestone for the finished rooms inside the addition when you’re ready to talk interiors.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Owens Corning Home Additions & ADU Is Failing
An envelope failure announces itself quietly at first. These are the five we see most in Las Vegas homes, and what each one usually means.
- Soft or bubbling drywall on an exterior wall. Moisture is getting past the weather barrier or the foam board’s taped seams. In Las Vegas, wind-driven rain during monsoon season finds the gaps a dry-season install left behind.
- Cold spots or hot spots along one wall in an otherwise comfortable room. Insulation has settled, compressed, or was never installed to full depth. A thermal scan or a careful probe finds where the R-value dropped off.
- Foam sheathing separating from the studs. The adhesive or fasteners failed. This is more common on south- and west-facing walls where surface temps climb well past 150 degrees in summer.
- Condensation on interior walls or window frames during summer. The dew point is landing on the wrong side of the assembly – usually an R-value mismatch or a missing vapor-control layer.
- Rising cooling bills with no equipment change. Air is escaping through envelope gaps. Duct leakage and envelope leakage look the same on the bill until you test for both.
One thing about Las Vegas weather that catches out-of-town contractors: our dry heat is easy on some materials and brutal on others. UV exposure degrades foam board that’s left uncovered even for a few weeks, and a wall that performs fine in a humid climate can fail here because we get the heat without the moisture, and the materials were spec’d for the wrong problem.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Whole-addition and ADU pricing in Las Vegas ranges from $45,000 to $130,000 for a framed addition and $90,000 to $220,000 for an ADU. For an envelope repair or re-insulation on an existing Owens Corning assembly, we don’t publish a flat rate because the scope varies too much – call us and we’ll quote it in writing.
What drives the range on a full build:
- Square footage and foundation type. A slab addition is simpler than a raised or crawlspace build.
- Envelope spec. Foam thickness, batt R-value, and weather barrier grade all move the number.
- Roof tie-in. How the addition meets the existing roof determines a real chunk of framing cost.
- Permits and inspections. Clark County pulls and inspection fees are part of every quote, and so are the inspections themselves.
- Finishes inside. Cabinetry, counters, and flooring are the swing factor – we line-item every allowance so you see it.
Parts and labor are broken out separately on the quote. Every price change is a written change order before work proceeds – no surprise invoices at the end. Every completed job is backed by the written 90-Day Done Right Promise: if it’s not right, Tom comes back and makes it right on one call.
DIY or Call Us?
There’s a safe middle ground and a dangerous edge on this work. You can absolutely check a few things yourself: measure the foam board thickness on an exposed wall, look for gaps in the weather barrier at corners and penetrations, and note where you feel temperature swings. That’s useful information to have on hand when you call.
What you shouldn’t do is open up a finished wall to “see what’s in there” without a plan, or try to re-seal a weather barrier from the outside while it’s still serving as your moisture control layer – one wrong tape seam and you’ve moved the water problem somewhere you can’t see it. The bigger issue is what happens after: if you cut into the envelope, you’re now responsible for re-sealing it to code, and if the inspector asks for a permit and there isn’t one, you’re the one explaining it. That’s not a scare tactic, it’s just how Clark County works.
The honest split is this: let us look at it before you open it up. Estimates are free, and we’ll tell you whether it’s a small fix or a real envelope problem. Call (866) 814-4155 to schedule yours. We’re a Las Vegas contractor – we live here and we’ll see you at the hardware store.
FAQs
Foam board and quality batt insulation typically last 25 to 40 years in a Las Vegas assembly, but the weather barrier and the tape seams are the short-lived parts – they commonly fail in 10 to 20 years under our UV load and monsoon cycles. Call (866) 814-4155 for an exact assessment of your wall.
Usually yes. A failing weather barrier or a compressed batt section can be repaired without touching the framing, and envelope repairs are far cheaper than a rebuild. The one exception is widespread foam separation across multiple walls, which points to an installation or adhesive problem that needs a full re-skin. Call (866) 814-4155 to find out which one you have.
A framed addition typically takes 3 to 6 months from permit to final inspection, and an ADU runs 5 to 9 months depending on size, utilities, and Clark County review times. We don’t quote a firm schedule until permits are in hand, because a false date is worse than an honest range. Call (866) 814-4155 to start the conversation.
We buy Owens Corning foam, barrier, and insulation through our regular supply relationships and confirm the spec and R-value against the plans before ordering. Nothing shows up on site unlabeled, and you see it on the quote before it’s purchased. Call (866) 814-4155 for a written line-item estimate.
Barrett & Sons Construction is an owner-operated Las Vegas contractor. Tom Barrett’s name, address, and license number are published and verifiable – look them up before you sign anything. We answer the phone with a live person, 24/7, not a call center. Standing offers include $40 off any repair over $200, a free second opinion on any written estimate, no trip charge inside the county, and a permanent 10% Senior & Veteran discount. Call (866) 814-4155 for a free estimate.
Written by the team at Barrett & Sons Construction Las Vegas, serving Las Vegas and nearby areas.