Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Ameristar Driveway & Pavers: The Las Vegas Owner’s Guide
We install and repair Ameristar-compatible paver driveways and hardscape in Las Vegas, and a full paver driveway typically runs $7,000 – $18,000 installed, with repairs and reset work priced far lower. Most Las Vegas owners discover the problem the same way: a paver lifts at the driveway apron after a summer of heat cycling, joints wash out during a monsoon dump, or a hairline crack opens along the garage approach and starts catching tires. By the time you’re reading this, the failure has usually been visible for a season or two. What follows is how to identify your Ameristar system, what actually fails in this desert, and what honest replacement costs in Las Vegas.
Which Ameristar Models This Applies To
Ameristar makes retaining wall block and hardscape accessories rather than the paving stones themselves in most residential lines, so the first job is figuring out what you actually have. Check the wall block behind or beside the driveway for an Ameristar stamp on the block face or the cap. Look for the product name molded into the back of the block, usually a short word or code. Measure one block face and its depth; Ameristar’s residential retaining lines run in set face dimensions, and matching the wrong series means caps that don’t seat and corners that don’t lock.
On the paver field itself, pull one loose unit from a failed joint and measure length, width, and thickness in millimeters. Most Las Vegas paver driveways sit on a 60mm or 80mm unit, and 80mm is the right call for a driveway that takes a full-size truck in summer heat. If the paver field is a Belgard or Techo-Bloc product sitting above an Ameristar wall, that’s a common and perfectly normal combination, and we carry both.
OEM versus aftermarket is a real decision here. Ameristar wall caps and corner units are worth matching to the original series because the interlock geometry is what holds the wall. For field pavers, a quality aftermarket unit in the same dimension and thickness is often the smarter buy, and it lets you match color to what’s already sun-faded. We are an independent installer and not affiliated with Ameristar, so we’ll tell you plainly when an exact match matters and when it doesn’t.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Ameristar Driveway & Pavers Is Failing
- Paver lift or rocking at the apron. The base has settled or the edge restraint has let go, usually where the driveway meets the street and traffic load is heaviest. Once a unit rocks, the bedding sand under it is already gone.
- Joint sand washing out after monsoon season. Las Vegas gets its rain in bursts, and poly sand that wasn’t properly compacted or was installed in the wrong temperature range erodes fast. Bare joints let water into the base, and the base is where driveways fail.
- Hairline cracks running along the garage approach. Thermal movement across a 140-degree summer surface is hard on any hardscape. Cracks that follow a straight line usually mean a control joint or base issue rather than a bad paver.
- Wall block bulging or leaning. On Ameristar retaining systems, this almost always traces to missing geogrid, poor drainage behind the wall, or backfill that wasn’t compacted in lifts. The wall didn’t fail; the soil behind it did.
- Efflorescence and color fade. White mineral bloom on the face is common in our alkaline soil and hard water. Some of it washes off; persistent bloom plus chalky color usually means the sealer has worn through and the surface is unprotected.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s what hardscape work actually runs in Las Vegas, parts and labor included:
| Work | Installed range |
|---|---|
| Paver driveway installation | $7,000 – $18,000 |
| Paver patio installation | $3,500 – $11,000 |
| Concrete driveway installation | $4,500 – $12,000 |
| Driveway replacement | $5,000 – $14,000 |
| Driveway sealing | $250 – $700 |
The range is driven by square footage, whether the base has to be excavated and rebuilt, edge restraint and drainage work, and the paver series you choose. Base prep is the cost nobody wants to pay for and everybody regrets skipping: in Las Vegas caliche soil, a driveway installed over an unprepared base will fail again in a few summers. Every change to scope arrives as a written change order before we touch the job, and every hardscape job we complete is backed by our written 90-Day Done Right Promise. Permits are pulled and inspections signed on eligible work.
DIY or Call Us?
You can safely handle the diagnosis. Pull a loose paver and look at the sand bed under it. Check your downspouts and grade. Photograph the failing area with a tape measure in frame. None of that is risky, and it speeds up a real quote.
Where owners get hurt is the rebuild. Reset pavers skinned over a failed base fail again within a season, and a leaning Ameristar retaining wall is a genuine safety concern. A wall carrying soil load can come down on someone, and stacked block is heavier than it looks. Don’t try to pull a bulging wall apart yourself, and don’t dig out a base near a wall footing. Call (866) 814-4155 and we’ll look at it, tell you what’s actually wrong, and give you a free second opinion on any written estimate you already have.
FAQs
A properly installed paver driveway with an 80mm unit over a compacted, well-drained base should give you 25 to 30 years here, and the pavers themselves often outlast the base. What shortens that in Las Vegas is heat cycling, monsoon-driven water getting under the surface, and skipping joint sand top-ups.
Yes, in most cases. Isolated rocking units, washed joints, and a settled apron can be lifted, re-bedded, and re-sanded without tearing out the whole driveway. If the base has failed across a large area or an Ameristar wall is bulging, partial rebuild is the honest answer rather than a patch.
A typical Las Vegas driveway tear-out and reinstall runs several days to about a week, depending on square footage, base depth, and drainage work. Sealing is usually scheduled after the pavers have had time to settle, and we put that timeline on the written scope so you know when the crew is on site and when they’re done.
We order materials specific to your project after the on-site measure, matching the Ameristar series on any wall work and confirming paver dimension and thickness against what’s already installed. Nothing gets ordered from a guess off a photo. Ask about our standing offers while you’re at it: $40 off any repair over $200, free second opinion on any written estimate, no trip charge inside the county, and a permanent 10% Senior & Veteran discount.
If your Ameristar driveway or wall is telling you it’s tired, call (866) 814-4155 for a free estimate. A live person answers, day or night. We also install KraftMaid, Cambria, and Silestone on the interior side if you’re tackling more than the driveway this year, and every job gets the same written scope and change orders before work starts. Ask anyone on your street, or look up the license number yourself.
Written by the team at Barrett & Sons Construction Las Vegas, serving Las Vegas and nearby areas.