Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Plant Prefab Driveway & Pavers: The Las Vegas Owner’s Guide
We install Plant Prefab-compatible driveways and paver surfaces across the Las Vegas valley, with typical installed paver work running $7,000 to $18,000 depending on square footage, base prep, and pattern. We’re an independent service provider, not affiliated with Plant Prefab. Most Las Vegas owners find out something is wrong the same way: a hairline crack spreads across three pavers in one summer, a corner lifts after the first monsoon drain-off, or the driveway starts holding water in a low spot that wasn’t there two years ago. Then the quotes start, and the numbers don’t match each other.
Which Plant Prefab Models This Applies To
Plant Prefab builds modular and panelized homes across several product lines, and the driveway and paver scope isn’t tied to the house model so much as it’s tied to what was actually laid on your lot. A Veev-style single-family build, a multi-unit stack, and a backyard ADU can all sit on the same product family and still have completely different hardscape drawings. That’s the compatibility gotcha nobody mentions: the model number on your home doesn’t tell us your paver spec.
Here’s how we identify what you have:
- Look at the drawing set. Your build documents will name the paver series, thickness, and laying pattern. If you don’t have them, the county permit file for your address usually does.
- Measure a single unit. Standard pavers run 2 3/8 inches thick, with 60mm and 80mm units used where vehicles roll. If you measure 1 5/8 inches, you have a pedestrian-grade unit that was never meant for a driveway.
- Check the edge restraint. Plant Prefab builds typically specify a concealed edge restraint rather than a visible soldier course. If yours has no restraint at all, that explains the spreading.
On the OEM versus aftermarket question: pavers are not a proprietary part. We match the series and thickness from manufacturers with published spec sheets, and we tell you the brand before you sign anything. Insist on that with anyone you hire. The same applies to the KraftMaid and Cambria lines we install in Plant Prefab kitchens, and to Silestone when a homeowner wants quartz instead.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Plant Prefab Driveway & Pavers Is Failing
Las Vegas hardscape fails differently than hardscape in wet climates. Our swing between 110-degree summers and winter overnight freezes works the base, and the caliche layer under a lot of valley soil holds water instead of draining it. That combination shows up in five predictable ways.
- Paver heave in a line across the drive. A freeze-thaw cycle lifts a row of units together. It almost always traces back to a shallow base, not bad pavers.
- Sunken ruts where your tires track. The base wasn’t compacted in lifts. Tires find the soft spot within two summers and never let go of it.
- Cracks that run paver to paver. The units are fine; the joint sand has washed out and the pavers are grinding against each other. Left alone, corners chip and the pattern starts walking.
- Efflorescence and white haze that keeps coming back after rain. Moisture is trapped under the surface with nowhere to go. A poly sand refresh buys time; drainage work fixes it.
- Water pooling near the garage apron. The slope has fallen below the drain line, or the original grading wasn’t tied to the apron correctly. This one is worth a look early, because it works its way toward your foundation.
If your drive is concrete rather than pavers, the failures read differently: slab cracks that widen after a hot week, spalling at the apron, and joints that have pushed up against the garage. We handle those too, in the $4,500 to $12,000 range for a concrete install.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
For a Las Vegas paver driveway, most of our jobs land between $7,000 and $18,000 installed. What moves you from one end of that to the other: square footage, whether the old surface and base come out, how deep the base has to go for your soil, the paver series you pick, and whether drainage has to be reworked at the apron. A full driveway replacement, including tear-out, runs $5,000 to $14,000 on the concrete side. Sealing alone is $250 to $700, and it’s the cheapest way to buy a couple of years if the surface is sound but tired.
Your written estimate is line-itemed: removal, base material, compaction, restraint, pavers, sand, and cleanup. Every allowance is on the paper. Any change after that comes as a written change order before we touch the job. Permits get pulled and inspections signed wherever the work is eligible, and the whole job sits under our 90-Day Done Right Promise: if it isn’t right, Tom comes back.
DIY or Call Us?
Pavers over a failing base are not a weekend job, and we’ll say that plainly rather than sell you a wheelbarrow. A paver driveway is a structural system: excavation, compacted base in lifts, edge restraint, and slope that sheds water away from the garage. Most homeowner installs fail at exactly two points, compaction and slope, and both fail quietly for a year before they show. There’s no serious injury risk here the way there is with a garage door spring, but there’s a real risk of spending a Saturday, a few hundred dollars in material, and a full season before you’re back to the same crack.
What you can safely check yourself: measure one paver’s thickness, photograph the low spots after a hose run, and pull your permit file for the original spec. Then call us at (866) 814-4155 and we’ll tell you what we’d do, free.
FAQs
A properly based paver driveway should hold 25 to 30 years in Las Vegas, and the pavers themselves often outlast the base. The failures we see at 8 to 12 years almost always trace to base prep or drainage, not the units.
Often, yes. If one section has heaved or rutted and the rest of the drive is sound, we can lift that section, rework the base, and reset the original pavers. That’s usually a fraction of a full replacement, and we’ll tell you honestly if it’s not worth it. Call (866) 814-4155 for a free estimate.
A typical Las Vegas driveway runs three to five working days, weather permitting: one to two days of tear-out and base, one to two laying, one for restraint, sand, and cleanup. Larger drives or ones needing drainage rework add a day or two. We don’t promise same-day work on a hardscape job, because it would be a lie.
We match the series, thickness, and color from the build documents or the permit file, then confirm the manufacturer with you before ordering. Nothing shows up on site that you haven’t seen on paper first.
Call Barrett & Sons Construction Las Vegas at (866) 814-4155 for your free estimate. A live person answers, day or night, and we’ll walk your drive together before anyone quotes a number. Current standing offers include $40 off any repair over $200, a free second opinion on any written estimate, no trip charge inside the county, and a permanent 10% senior and veteran discount.
Written by the team at Barrett & Sons Construction Las Vegas, serving Las Vegas and nearby areas.