Bathroom remodeling
Kitchen remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Quikrete Bathroom Remodeling: The Las Vegas Owner’s Guide
Quikrete bathroom remodeling in Las Vegas typically runs $9,000 – $28,000 for a full bath, and $5,000 – $12,000 for a small or half bath. You’re probably here because something already failed: cracked grout lines that keep coming back, a mortar bed that’s gone soft underfoot, or thinset that broke loose six months after the tile went down. In a Las Vegas bathroom, that usually isn’t bad luck. It’s the wrong Quikrete product for the substrate, or the right product poured over a slab that never got a moisture test.
Barrett & Sons Construction is an independent service provider. We install and repair Quikrete-based bathroom work, and we’re not affiliated with Quikrete.
Key Takeaways
- Full bathroom remodel in Las Vegas: $9,000 – $28,000. Small bathroom: $5,000 – $12,000.
- Most failures we see in Clark County trace to moisture vapor below the slab, not the product.
- Every scope and allowance goes in writing before work starts, with a written change order for any price shift.
- Backed by our 90-Day Done Right Promise, in writing on the contract.
Which Quikrete Products Apply to Your Bathroom
Quikrete’s bathroom line spans a few product families, and mixing them up is the most common error we correct. The products you’ll run into on bathroom work:
- Sand Topping Mix (1103) – for thin beds, repairs, and patching shallow areas. Not for a full shower pan.
- Floor Mud / Deck Mud – the correct choice for a sloped shower pan. Comes in mix ratios that hold a slope without sagging.
- Fast-Setting Concrete – fast cure, low strength. Wrong for tile beds, right for anchoring a tub drain or setting a closet flange in a quick patch.
- Quikrete Vinyl Concrete Patcher – resurfacing only. Won’t hold a tile bed.
Read the bag label closely. Quikrete’s deck mud and topping mixes look near-identical on a shelf, and both are gray powder in a similar bag. The label tells you the mix ratio and the intended bed thickness. If you’re patching an existing shower pan, measure the depth first – thinner than the bag’s minimum and the mix goes brittle, thicker and it won’t slope.
For a replacement, we use OEM Quikrete where the existing bed or patch needs to match, and quality equivalents where the application allows. Both are spec’d to the same standard. The decision usually comes down to cure time and whether the slab is enclosed.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Quikrete Bathroom Remodeling Is Failing
- Tile that sounds hollow underfoot. Thinset has debonded from the mortar bed. Tap a few tiles with a screwdriver handle – a hollow ring means air under the tile, and that tile will pop.
- Grout lines cracking in a repeating grid. The bed is moving under the tile. In Las Vegas bathrooms, this often means the slab was poured without a vapor barrier, or the mix was dry-set without the right additive.
- Soft or sandy texture at the shower curb or pan edge. The mortar never fully cured or absorbed moisture and broke down. This one needs to come out; patching it makes it worse.
- Water pooling in a low spot at the shower pan. The bed was mixed too wet and never held its slope. Quikrete deck mud will hold a slope – but only if it’s mixed to spec and packed properly.
- White crusty buildup on grout or along the pan edge. Efflorescence – moisture is wicking through the concrete from below. That’s a slab issue, not a Quikrete issue, and it needs a moisture test before any new tile goes down.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s the honest price picture for a Quikrete-based bathroom remodel in Las Vegas:
| Scope | Installed Range |
|---|---|
| Full bathroom remodel | $9,000 – $28,000 |
| Small bathroom remodel | $5,000 – $12,000 |
| Walk-in shower installation | $4,500 – $12,000 |
| Tub-to-shower conversion | $3,500 – $10,000 |
| Shower replacement (pan and tile) | $3,000 – $8,500 |
| Bathroom vanity installation | $800 – $3,000 |
What drives the number: slab condition, whether the old pan comes out clean, tile choice, and whether permits are needed – and they usually are for a full bath re-tile in Clark County. Quikrete mortar and thinset runs a few hundred dollars on a full bath; most of the money is in labor, waterproofing, and the tile set.
Every line item, every scope, every allowance is in the estimate before work starts. If the number changes, you get a written change order first. And the finished job is backed by our 90-Day Done Right Promise in writing.
DIY or Call Us?
Mixing Quikrete to spec and setting a shower pan slope is not a beginner’s job. The safety and waterproofing risks are real: a poorly sloped pan holds water against the subfloor, and a pan that gives way underfoot is a fall hazard in a wet room.
What you can safely do:
- Tap-test tiles for hollow spots and photograph them.
- Measure any pooling depth at the shower pan with a level.
- Read the product label and confirm your mix ratio.
- Check the grout for efflorescence and photograph it.
Where DIY goes wrong: mixing the bed too wet to save time, skimping the slope, or tiling over a slab with rising moisture. We see it three or four times a year in Las Vegas bathrooms, and the fix costs more than doing it right the first time.
Call (866) 814-4155 for a free estimate. We’ll bring a moisture meter, look at the existing bed, and give you a number in writing.
FAQs
A properly installed Quikrete deck-mud shower pan lasts 20 to 30 years. The failure here isn’t the mortar; it’s what’s under it. Las Vegas slabs can push moisture up through the concrete, which breaks down the mortar bed from below if there’s no vapor barrier or surface waterproofing.
Sometimes, yes – if the failure is shallow (a few cracked tiles, a thin patch), a spot repair with Quikrete Sand Topping Mix can hold. If the bed is soft, hollow underfoot, or showing efflorescence, it has to come out. Patching those cases doesn’t fix the underlying moisture, and the new patch fails in a year. Call us for an honest read on which side of that line you’re on.
A full bathroom remodel is 2 – 3 weeks of working days. A shower pan replacement alone is 4 – 6 days – demo, substrate repair, bed cure, waterproof, tile set, grout, and cure time before use. Fast-set products reduce the cure window but don’t shorten the tile-set timeline.
We match the mix to the application – deck mud for sloped pans, topping mix for shallow patches, thinset with the right additive for tile over slab. On every job, we bring the specified product and document the label, so you can verify the mix match to the standard the job calls for.
Call (866) 814-4155 to schedule your free estimate. We’ll give you a written line-item price for your Las Vegas bathroom, a written change order for any scope shift, and our 90-Day Done Right Promise on every eligible job. We also work with KraftMaid, Cambria, and Silestone on bath vanities and counters when you’re ready for those. We pull the permits. We take the 10% Senior & Veteran discount off any qualifying job, and the $40 Off Any Repair Over $200 applies whenever it fits. Free second opinion on any written estimate – bring it in.
Written by the team at Barrett & Sons Construction Las Vegas, serving Las Vegas and nearby areas.